Notice: Radxa Wiki is no longer maintained and content is for reference only. Please visit the latest Radxa Documentation site:
docs.radxa.com
Difference between revisions of "Rock3/dev"
< Rock3
| Line 41: | Line 41: | ||
* [[rock3/dev/usb-gadget | USB Gadget Support]] | * [[rock3/dev/usb-gadget | USB Gadget Support]] | ||
* [[rock3/dev/qt | porting qt to rockchip platforms]] | * [[rock3/dev/qt | porting qt to rockchip platforms]] | ||
| − | + | * [[rock3/dev/qt_and_libwiringX | Embed wiringX into the qt project]] | |
------ | ------ | ||
Latest revision as of 09:24, 5 June 2023
ROCK 3 > Development Guide
This page describes development tips for ROCK 3.
- How to use Radxa Official Debian
- How to use Radxa Official Ubuntu
- Radxa APT
- Radxa Configuration
- Device Tree Overlays
- debos-radxa build Radxa official system images
- Build Debian from scratch
- Using Serial Console
- PXE Boot
- Using Android Debug Bridge
- Using CAN bus communication
- Using Coral Edge TPU
- NPU Run Test
- RKNN Toolkit with PC
- Install libmraa
- libmraa on Radxa CM3 IO
- SPI + NVME SSD boot
- Change kernel params
- Mainline Development
- Unified Extensible Firmware Interface
- Use SATA SSD on Radxa CM3 IO
- Install Docker Engine on Debian
- USB Device Network
- AP mode on Radxa E25
- Radxa E25 as USB Mass Storage
- Radxa E23 Audio Test
- Use Radxa Display 10HD on Radxa CM3 IO
- Use the debug serial port as a normal serial port
- USB Gadget Support
- porting qt to rockchip platforms
- Embed wiringX into the qt project