Please enable javascript, or click here to visit my ecommerce web site powered by Shopify.
Jump to: navigation, search

Difference between revisions of "Rock5/install/usb-install-rock-5b"

< Rock5‎ | install
 
Line 6: Line 6:
 
== Install the image to eMMC from USB port ==
 
== Install the image to eMMC from USB port ==
  
Rock 5 supports Maskrom mode, which is a special operation mode for CPU to wait for USB OTG port command. The PC tools we use to communicate with rock 5 in Maskrom mode are the rkdeveloptool and RKDevTool. We use the rkdeveloptool in Linux/macOS and the RKDevTool under Windows.  
+
Rock 5 supports Maskrom mode, which is a special operation mode for CPU to wait for USB OTG port command.
 +
The PC tools we use to communicate with rock 5 in Maskrom mode are the '''rkdeveloptool''' and '''RKDevTool'''.  
 +
We use '''the rkdeveloptool in Linux/macOS ''' and '''the RKDevTool under Windows'''.
  
 
=== Requirement ===
 
=== Requirement ===

Latest revision as of 02:35, 22 September 2022

    ROCK 5 >  Installation >  Install the Image to eMMC from USB port

Install the image to eMMC from USB port

Rock 5 supports Maskrom mode, which is a special operation mode for CPU to wait for USB OTG port command. The PC tools we use to communicate with rock 5 in Maskrom mode are the rkdeveloptool and RKDevTool. We use the rkdeveloptool in Linux/macOS and the RKDevTool under Windows.

Requirement

  • Rock 5B
  • type-c cable
  • emmc module
  • Windows/linux/macOS PC

Install Tools&Drivers

Please check this guide, Install rockchip flash tools under Windows/Linux/MacOS PC.

Boot the board to Maskrom mode

Rock-5b-typec-maskrom.jpeg

To boot ROCK 5B to Maskrom mode is simple:

  • Power off the board.
  • Press the golden button and hold it.
  • Plug the USB-A to Type-C cable to ROCK 5B Type-C port, the other side to PC.
  • Release the golded button.
  • Check usb device
    • For macOS host: lsusb result: Bus 002 Device 032: ID 2207:350b Fuzhou Rockchip Electronics Co., Ltd. Composite Device
    • For Linux host: lsusb result: Bus 001 Device 112: ID 2207:350b Fuzhou Rockchip Electronics Company
    • For Windows host: Open RKDevTool and you would see the device is in Found One MASKROM Device.

Get RK3588 loader and system image

ROCK 5B

Write system image to eMMC module

Linux/MacOS

On your PC, run the rkdeveloptool

sudo rkdeveloptool ld
DevNo=1	Vid=0x2207,Pid=0x350b,LocationID=106	Maskrom

Download the loader (flash helper) to init the ram and prepare the flashing environment etc. If you don't have it, you can download it from here

sudo rkdeveloptool db /path/to/rk3588_spl_loader_v1.08.111.bin

Write SPI image to SPI Nor Flash on board.

You can use our pre-built files.

sudo rkdeveloptool wl 0 rock-5b-debian-bullseye-xfce4-arm64-20220919-0912-gpt.img				

Reboot the device

sudo rkdeveloptool rd

now, the device should boot on eMMC.

Troubleshooting