Difference between revisions of "Rock3/dev"
< Rock3
| Line 12: | Line 12: | ||
* [[radxa-configuration | Radxa Configuration]] | * [[radxa-configuration | Radxa Configuration]] | ||
* [[Device-tree-overlays | Device Tree Overlays]] | * [[Device-tree-overlays | Device Tree Overlays]] | ||
| + | |||
------ | ------ | ||
| Line 34: | Line 35: | ||
* [[rock3/dev/ap-mode-on-radxa-e25 | AP mode on Radxa E25]] | * [[rock3/dev/ap-mode-on-radxa-e25 | AP mode on Radxa E25]] | ||
* [[rock3/dev/radxa-e25-ums | Radxa E25 as USB Mass Storage]] | * [[rock3/dev/radxa-e25-ums | Radxa E25 as USB Mass Storage]] | ||
| − | + | * [[rock3/dev/radxa-e23-audio | Radxa E23 Audio Test]] | |
------ | ------ | ||
Revision as of 06:51, 13 October 2022
ROCK 3 > Development Guide
This page describes development tips for ROCK 3.
- How to use Radxa Official Debian
- How to use Radxa Official Ubuntu
- Radxa APT
- Radxa Configuration
- Device Tree Overlays
- debos-radxa build Radxa official system images
- Build Debian from scratch
- Using Serial Console
- PXE Boot
- Using Android Debug Bridge
- Using CAN bus communication
- Using Coral Edge TPU
- NPU Run Test
- Install libmraa
- libmraa on Radxa CM3 IO
- SPI + NVME SSD boot
- Change kernel params
- Mainline Development
- Unified Extensible Firmware Interface
- Use SATA SSD on Radxa CM3 IO
- Install Docker Engine on Debian
- USB Device Network
- AP mode on Radxa E25
- Radxa E25 as USB Mass Storage
- Radxa E23 Audio Test