Difference between revisions of "Rock3/dev"
< Rock3
| Line 24: | Line 24: | ||
* [[rock3/dev/npu-run-test | NPU Run Test]] | * [[rock3/dev/npu-run-test | NPU Run Test]] | ||
* [[rock3/dev/libmraa | Install libmraa]] | * [[rock3/dev/libmraa | Install libmraa]] | ||
| + | * [[rock3/dev/libmraa-cm3-io | libmraa on Radxa CM3 IO]] | ||
* [[rock3/install/spi | SPI]] + [[rock3/install/nvme | NVME SSD]] boot | * [[rock3/install/spi | SPI]] + [[rock3/install/nvme | NVME SSD]] boot | ||
* [[rock3/dev/change-kernel-params | Change kernel params ]] | * [[rock3/dev/change-kernel-params | Change kernel params ]] | ||
Revision as of 06:19, 8 October 2022
ROCK 3 > Development Guide
This page describes development tips for ROCK 3.
- How to use Radxa Official Debian
- How to use Radxa Official Ubuntu
- Radxa APT
- Radxa Configuration
- Device Tree Overlays
- debos-radxa build Radxa official system images
- Build Debian from scratch
- Using Serial Console
- PXE Boot
- Using Android Debug Bridge
- Using CAN bus communication
- Using Coral Edge TPU
- NPU Run Test
- Install libmraa
- libmraa on Radxa CM3 IO
- SPI + NVME SSD boot
- Change kernel params
- Mainline Development
- Unified Extensible Firmware Interface
- Use SATA SSD on Radxa CM3 IO
- Install Docker Engine on Debian
- USB Device Network
- AP mode on Radxa E25
- Radxa E25 as USB Mass Storage