Difference between revisions of "RockpiS/hardware/revisions"
| Line 20: | Line 20: | ||
===V1.2=== | ===V1.2=== | ||
| − | * Add full PDM support on GPIO header according the discussion on the forum | + | * Add full PDM support on GPIO header according to the [https://forum.radxa.com/t/audio-support-rock-pi-s/1686/12 discussion on the forum] |
* Swap ethernet status led JP1 pin 11/12 and pin 13/14 | * Swap ethernet status led JP1 pin 11/12 and pin 13/14 | ||
* Change resistor R9608 R90304 value to reduce brightness of LED | * Change resistor R9608 R90304 value to reduce brightness of LED | ||
* Add 5.1K pull down resistor on type C CC pin :-) | * Add 5.1K pull down resistor on type C CC pin :-) | ||
Revision as of 07:27, 17 October 2019
ROCK Pi S > Hardware > Hardware Revisions
This page describe the hardware revisions of ROCK Pi S. For the different models and features of each models, please refer models page.
V1.0
- This is the first version of the board, 15 samples are made
V1.1
- Board color changes to yellow :-)
- Change GPIO header to be compatible with ROCK Pi 4
- Swap USB Host on type A and USB OTG on type C, make more sense with single cable for power and adb
- Change SPI flash to SD Nand
V1.2
- Add full PDM support on GPIO header according to the discussion on the forum
- Swap ethernet status led JP1 pin 11/12 and pin 13/14
- Change resistor R9608 R90304 value to reduce brightness of LED
- Add 5.1K pull down resistor on type C CC pin :-)