Difference between revisions of "Rockpi4/hardware/HATs"
(Created page with "{{rockpi4_header}} {{Languages|rockpi4/hardware/HATs}} ROCK Pi 4 > Hardware > HATs == Introductions ==...") |
|||
| Line 13: | Line 13: | ||
=== RaZberry/RaZberry2 === | === RaZberry/RaZberry2 === | ||
Zwave module by Z-Wave.Me. It uses uart2 TX/RX on the 40PIN GPIO. Tested working on ROCK Pi 4 by disabling the serial console on uart2. See [https://forum.radxa.com/t/configuring-kernel-before-building/123/22 discussion on the forum]. | Zwave module by Z-Wave.Me. It uses uart2 TX/RX on the 40PIN GPIO. Tested working on ROCK Pi 4 by disabling the serial console on uart2. See [https://forum.radxa.com/t/configuring-kernel-before-building/123/22 discussion on the forum]. | ||
| + | |||
| + | === ROCK PI POE HAT === | ||
Revision as of 01:20, 17 May 2019
ROCK Pi 4 > Hardware > HATs
Introductions
A HAT (Hardware Attached on Top) is an add-on board for ROCK Pi 4 that conforms to a specific set of rules that will make life easier for users.
HATs Lists
A list of working HATs tested by radxa and the community.
RaZberry/RaZberry2
Zwave module by Z-Wave.Me. It uses uart2 TX/RX on the 40PIN GPIO. Tested working on ROCK Pi 4 by disabling the serial console on uart2. See discussion on the forum.