Difference between revisions of "Zero2/Hardware/Revisions"

Revision as of 02:50, 10 February 2022

 Radxa Zero 2 >  Hardware >  Hardware revisions

Version	Comment
1.0	Initial version Lack of clearance around microSD card slot resulting the card will be blocked for insertion. (Workaround: lift the card corner slightly during insertion, so the card can "sit" on that blocking component when fully inserted) TYPE-C headers are slightly misaligned. PCB mounting hole location is different from Zero, as such a proposed universal case cannot share holes on the USB connector side. USB 3 port may not be recognized by the board. (Manually fixed on sample boards) GPIO pin 16 and 24 are connected on the same bus. 16 will be replaced by SARADC_CH1. GPIO pin 36 is an open drain pin. Works fine for input but need pull up for output. Fan's PWM generator is occupied by VDDCPU_B. Preferably an unused PWM pin should go there. Otherwise `gpio-fan` will be used in device tree. Green LED might be too bright
1.1	Pending

@@ Line 13: / Line 13: @@
 | Initial version
 * Lack of clearance around microSD card slot resulting the card will be blocked for insertion. (Workaround: lift the card corner slightly during insertion, so the card can "sit" on that blocking component when fully inserted)
-* TYPC-C headers are slightly misaligned.
+* TYPE-C headers are slightly misaligned.
 * PCB mounting hole location is different from Zero, as such a proposed universal case cannot share holes on the USB connector side.
 * USB 3 port may not be recognized by the board. (Manually fixed on sample boards)