Please enable javascript, or click here to visit my ecommerce web site powered by Shopify.
Jump to: navigation, search

Difference between revisions of "Rock/Loader mode"

 
(One intermediate revision by one other user not shown)
Line 10: Line 10:
  
 
=== Board not powered on ===
 
=== Board not powered on ===
If the board is not powered on, to switch Radxa Rock to recovery mode, simply press and hold the RECOVERY key (the one to the left of the leftmost USB port) and connect the USB OTG cable to your PC. The board will turn on emitting a red light and will stay on recovery mode waiting for commands. If no recovery activity is found, the board will turn off after two minutes.
+
If the board is not powered on, to switch Radxa Rock to loader mode, simply press and hold the RECOVERY key (the one to the left of the leftmost USB port) and connect the USB OTG cable to your PC. The board will turn on emitting a red light and will stay on loader mode waiting for commands. If no activity is found, the board will turn off after two minutes.
  
 
[[File:guard_1.jpg]]
 
[[File:guard_1.jpg]]
Line 16: Line 16:
 
=== Board is powering on ===
 
=== Board is powering on ===
  
When the board is power on, you can plug the OTG cable to your PC first and then one finger press and hold the RECOVERY key, another finger press the RESET key. The board will reboot and stay on recovery mode waiting for commands. If no recovery activity is found, the board will turn off after two minutes.
+
When the board is power on, you can plug the OTG cable to your PC first and then one finger press and hold the RECOVERY key, another finger press the RESET key. The board will reboot and stay on loader mode waiting for commands. If no activity is found, the board will '''turn off''' after two minutes.
 +
 
 +
[[Category:Rock]]

Latest revision as of 12:33, 5 January 2015

Loader mode on Radxa Rock


Note: The recovery key is the one near the USB host port, at the bottom of the board, there is label. Make sure not pressing the wrong key(the reset key).

Board not powered on

If the board is not powered on, to switch Radxa Rock to loader mode, simply press and hold the RECOVERY key (the one to the left of the leftmost USB port) and connect the USB OTG cable to your PC. The board will turn on emitting a red light and will stay on loader mode waiting for commands. If no activity is found, the board will turn off after two minutes.

Guard 1.jpg

Board is powering on

When the board is power on, you can plug the OTG cable to your PC first and then one finger press and hold the RECOVERY key, another finger press the RESET key. The board will reboot and stay on loader mode waiting for commands. If no activity is found, the board will turn off after two minutes.