Rock/extension header
Contents
80 pin 2.54mm extension header
Radxa Rock(pro/lite) has two 2.54mm 40 pins(20*2) extension header on board, which includes GPIO, I2C, SPI, Line in, USB 2.0, PWM, ADC, LCD etc interfaces. You can easily connect the breadboard or other sensor board to the rock. All the rock/rock pro/rock lite is compatible on the extension header, so it works on any hardware revision.
Extension header as GPIO only
WARNING: the above schematic is wrong for J12 header, the pins 26, 27, 28 and 30 can not be used as GPIOs.
Hopefully someone will correct this image and remove this warning...
Other function on extension header
Thanks @zwanni for the picture and the excel table.
Full function table
| J8 (Near USB host and RTC battery) | |||||||
|---|---|---|---|---|---|---|---|
| USB Host | |||||||
| 1 | Ground | 2 | VCC-5V | ||||
| 3 | HOST_DP2 | 4 | HOST_DM2 | ||||
| Audio Input | |||||||
| 5 | LINE Left | 6 | LINE Right | ||||
| GPIO | |||||||
| 7 | GPIO0_A7 | 8 | GPIO0_A6 | ||||
| 9 | GPIO0_B1 | 10 | GPIO0_A1 | ||||
| PWM | |||||||
| 11 | PWM2 | GPIO3_D5 | 12 | PWM1 | GPIO3_D4 | ||
| UART0 | |||||||
| 13 | UART0_RX | GPIO1_A0 | 14 | UART0_TX | GPIO1_A1 | ||
| 15 | UART0_CTS | GPIO1_A2 | 16 | UART0_RTS | GPIO1_A3 | ||
| 17 | Ground | 18 | VCC-2.8V | ||||
| SPI1 / UART3 / GPS | |||||||
| 19 | SPI1_CSN0 | GPIO0_D7 | 20 | UART3_RTSN | GPIO1_B5 | ||
| 21 | SPI1_RX | GPIO0_D4 (GPS_PWR) | 22 | UART3_RX | GPIO1_B2 | GPS_MAG | |
| 23 | SPI1_CLK (GPS_SCLK) | GPIO0_D6 | 24 | UART3_TX | GPIO1_B3 | GPS_SIG | |
| 25 | SARADC_ANI2 (GPS_LRADC) | 26 | UART3_CTSN | GPIO1_B4 | GPS_CLK | ||
| 27 | GPIO0_A5 | 28 | SPI1_TX (GPS_MOSI) | GPIO0_D5 | |||
| I2C | |||||||
| 29 | Ground | 30 | VCCIO_WL | ||||
| 31 | I2C0_SCL | GPIO1_D1 | 32 | I2C0_SDA | GPIO1_D0 | ||
| ADC (Analog-to-digital converters) | |||||||
| 33 | SARADC_ANI0 | 34 | SARADC_ANI1 (RECOVERY) | ||||
| MISC | |||||||
| 35 | POWER_SW | 36 | PWR_EN | ||||
| 37 | HSIC_DATA | 38 | HSIC_STROBE | ||||
| 39 | Ground | 40 | VDD-5V | ||||
| J12 (Near Power Key and DC Jack) | |||||||
|---|---|---|---|---|---|---|---|
| LCD | |||||||
| 1 | Ground | 2 | LCDC0_D0 | ||||
| 3 | LCDC0_D1 | 4 | LCDC0_D2 | ||||
| 5 | LCDC0_D3 | 6 | LCDC0_D4 | ||||
| 7 | LCDC0_D5 | 8 | LCDC0_D6 | ||||
| 9 | LCDC0_D7 | 10 | LCDC0_D8 | ||||
| 11 | LCDC0_D9 | 12 | LCDC0_D10 | ||||
| 13 | LCDC0_D11 | 14 | LCDC0_D12 | ||||
| 15 | LCDC0_D13 | 16 | LCDC0_D14 | ||||
| 17 | LCDC0_D15 | 18 | LCDC0_D16 | ||||
| 19 | LCDC0_D17 | 20 | LCDC0_D18 | ||||
| 21 | LCDC0_D19 | 22 | LCDC0_D20 | ||||
| 23 | LCDC0_D21 | 24 | LCDC0_D22 | ||||
| 25 | LCDC0_D23 | 26 | LCDC0_HSYNC | ||||
| 27 | LCDC0_VSYNC | 28 | LCDC0_DE | ||||
| 29 | Ground | 30 | LCDC0_CLK | ||||
| GPIO / PWM | |||||||
| 31 | GPIO0_B0 (LCD_EN) | 32 | GPIO0_A2 (BL_EN) | ||||
| 33 | PWM3 (LCD_BL) | GPIO3_D6 | 34 | SPI0_CSN1 | GPIO1_B7 | ||
| SPI0 / UART1 | |||||||
| 35 | SPI0_CSN0 | GPIO1_A7 | UART1_RTSN | 36 | SPI0_RXD | GPIO1_A4 | UART1_RX |
| 37 | SPI0_CLK | GPIO1_A6 | UART1_CTSN | 38 | SPI0_TXD | GPIO1_A5 | UART1_TX |
| 39 | VCC-5V | 40 | Ground | ||||
FPC extension header
Rock Pro and Lite(2014 Mid) has three FPC header at the back of the board.