Difference between revisions of "Rock/Loader mode"
PeiYao Wang (Talk | contribs) (→Board not powered on) |
m (Naobsd moved page Rock/recovery mode to Rock/Loader mode: "recovery (mode)" should be used for recovery program in recovery partition) |
(No difference)
| |
Revision as of 23:44, 24 April 2014
Recovery Mode on Radxa Rock
Note: The recovery key is the one near the USB host port, at the bottom of the board, there is label. Make sure not pressing the wrong key(the reset key).
Board not powered on
If the board is not powered on, to switch Radxa Rock to recovery mode, simply press and hold the RECOVERY key (the one to the left of the leftmost USB port) and connect the USB OTG cable to your PC. The board will turn on emitting a red light and will stay on recovery mode waiting for commands. If no recovery activity is found, the board will turn off after two minutes.
Board is powering on
When the board is power on, you can plug the OTG cable to your PC first and then one finger press and hold the RECOVERY key, another finger press the RESET key. The board will reboot and stay on recovery mode waiting for commands. If no recovery activity is found, the board will turn off after two minutes.