Difference between revisions of "Rock5/hardware/camera/"
(→Software configuration) |
|||
| Line 14: | Line 14: | ||
==== Software configuration ==== | ==== Software configuration ==== | ||
| − | Add one line to file /boot/config.txt. Like this. | + | * Add one line to file /boot/config.txt. Like this. |
dtoverlay=rock-5ab-camera-imx415 | dtoverlay=rock-5ab-camera-imx415 | ||
| − | And then execute command. | + | * And then execute command. |
| − | update_extlinux.sh | + | # update_extlinux.sh |
| − | Reboot the device, you would see devices /dev/video0 to /dev/video19 are created. | + | * Reboot the device, you would see devices /dev/video0 to /dev/video19 are created. |
| − | + | * Start rkaiq camera preview. | |
| − | + | Execute the following command with root user in terminal on desktop. | |
| − | + | $ sudo su | |
| + | # gst-launch-1.0 v4l2src device=/dev/video11 ! video/x-raw,format=NV12,width=3840,height=2160, framerate=30/1 ! xvimagesink | ||
== USB Camera == | == USB Camera == | ||
Latest revision as of 09:50, 29 September 2022
ROCK 5 > Hardware > Camera module
Contents
MIPI Camera
Radxa Camera 4K
Hardware connection
Software configuration
- Add one line to file /boot/config.txt. Like this.
dtoverlay=rock-5ab-camera-imx415
- And then execute command.
# update_extlinux.sh
- Reboot the device, you would see devices /dev/video0 to /dev/video19 are created.
- Start rkaiq camera preview.
Execute the following command with root user in terminal on desktop.
$ sudo su # gst-launch-1.0 v4l2src device=/dev/video11 ! video/x-raw,format=NV12,width=3840,height=2160, framerate=30/1 ! xvimagesink
USB Camera
Troubleshooting
- Post your issue on the forum: https://forum.radxa.com/c/rock5