Cx at 09:56, 14 February 2022

2022-02-14T09:56:17Z

Shine at 03:21, 16 September 2020

2020-09-16T03:21:13Z

Hipboi: Created page with "{{rockpiX_header}} {{Languages|RockpiX/install/Ubuntu}} ROCK Pi X > Install > RockpiX/install/Ubuntu | Install Ubuntu to ROCK Pi X (..."

2020-08-25T07:07:48Z

Created page with "{{rockpiX_header}} {{Languages|RockpiX/install/Ubuntu}} ROCK Pi X > Install > RockpiX/install/Ubuntu | Install Ubuntu to ROCK Pi X (..."

New page

{{rockpiX_header}}
{{Languages|RockpiX/install/Ubuntu}}

[[rockpiX | ROCK Pi X]] > [[RockpiX/install | Install]] > [[RockpiX/install/Ubuntu | Install Ubuntu to ROCK Pi X (eMMC)]]

← Older revision		Revision as of 09:56, 14 February 2022
Line 67:		Line 67:

	[[File:install_ubuntu_interface.png \| 400px]]		[[File:install_ubuntu_interface.png \| 400px]]
		+
		+
		+	== FAQ ==
		+	1. [https://gist.github.com/cx-sawyer/f4f0a6198f738a986acbb71632af446a#file-readme-md How to enable AP6254 WiFi module]

← Older revision		Revision as of 03:21, 16 September 2020
Line 3:		Line 3:

	[[rockpiX \| ROCK Pi X]] > [[RockpiX/install \| Install]] > [[RockpiX/install/Ubuntu \| Install Ubuntu to ROCK Pi X (eMMC)]]		[[rockpiX \| ROCK Pi X]] > [[RockpiX/install \| Install]] > [[RockpiX/install/Ubuntu \| Install Ubuntu to ROCK Pi X (eMMC)]]
		+
		+	== Introduction ==
		+
		+	This article will teach you how to install ubuntu system to ROCK PI X.
		+
		+	== Prepare ==
		+	* Ubuntu ISO image - You need a copy of the ubuntu ISO image, which can be downloaded from [https://ubuntu.com/download/desktop Ubuntu].
		+	* USB drive - We need this as the installation media
		+	* ROCK Pi X - It doesn't matter if the board has OS running already or not, as long as we have proper BIOS installed, we can install a new OS
		+	* Keyboard/mouse and HDMI monitor for ROCK Pi X - We need to operate on ROCK Pi X
		+	* Another PC(HOST PC) running Ubuntu - We need to make bootable USB drive from iso on this PC
		+
		+	== Step 1: Make a bootable USB disk from Ubuntu ISO ==
		+	=== Linux Host ===
		+
		+	Plug in the U disk and use the command to view the device node of the U disk:
		+
		+	$ dmesg
		+	...
		+	[152495.190420] usb 2-1.1: new SuperSpeed Gen 1 USB device number 9 using xhci_hcd
		+	[152495.211005] usb 2-1.1: New USB device found, idVendor=2537, idProduct=1081, bcdDevice= 1.00
		+	[152495.211010] usb 2-1.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
		+	[152495.211013] usb 2-1.1: Product: NS1081
		+	[152495.211016] usb 2-1.1: Manufacturer: Norelsys
		+	[152495.211018] usb 2-1.1: SerialNumber: 81E22742AB574A1DAAB8A9FB1763CC
		+	[152495.213235] usb-storage 2-1.1:1.0: USB Mass Storage device detected
		+	[152495.213869] scsi host4: usb-storage 2-1.1:1.0
		+	[152498.161965] scsi 4:0:0:0: Direct-Access NORELSYS 1081 0 PQ: 0 ANSI: 6
		+	[152498.163651] scsi 4:0:0:0: Attached scsi generic sg2 type 0
		+	[152498.164259] sd 4:0:0:0: [sdc] 122683136 512-byte logical blocks: (62.8 GB/58.5 GiB)
		+	[152498.164602] sd 4:0:0:0: [sdc] Write Protect is off
		+	[152498.164606] sd 4:0:0:0: [sdc] Mode Sense: 43 00 00 00
		+	[152498.164874] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
		+	[152498.182278] sdc: sdc1 sdc2
		+	[152498.184061] sd 4:0:0:0: [sdc] Attached SCSI removable disk
		+
		+	After querying that the device node is sdc, use the dd command to install the ubuntu ISO image file to the U disk:
		+
		+	$ ls
		+	ubuntu-12.04.5-desktop-amd64.iso ubuntu-16.04.6-desktop-amd64.iso ubuntu-20.04-desktop-amd64.iso
		+	ubuntu-14.04.6-desktop-amd64.iso ubuntu-18.04.4-desktop-amd64.iso
		+
		+	$ sudo dd if=ubuntu-20.04-desktop-amd64.iso of=/dev/sdc bs=8M status=progress
		+	301989888 bytes (302 MB, 288 MiB) copied, 8 s, 36.8 MB/s
		+
		+	Wait for the installation is finished, U disk start disk production is completed.
		+
		+	== Step 2: Boot from USB disk ==
		+
		+	1. Plug the USB drive on ROCK Pi X, if your USB drive is USB 3.0, plug it to the ROCK Pi X USB 3.0 port is preferred.
		+
		+	2. Plug keyboard and HDMI monitor on ROCK Pi X
		+
		+	3. Power on the ROCK Pi X, keep pressing DEL on the keyboard until the BIOS screen is on HDMI
		+
		+	4. Go the last tab [Save & Exit] -> [Boot Override] of BIOS menu, select your USB drive and press '''Enter''' to boot.
		+
		+	[[File:Install_ubuntu_BIOS.png]]
		+
		+	== Step 3: Installation ==
		+
		+	Wait for some seconds and you see the familiar ubuntu installation screen, now you are ready to go.
		+
		+	[[File:install_ubuntu_interface.png \| 400px]]

RockpiX/install/ubuntu - Revision history

Cx at 09:56, 14 February 2022

Shine at 03:21, 16 September 2020

Hipboi: Created page with "{{rockpiX_header}} {{Languages|RockpiX/install/Ubuntu}} ROCK Pi X > Install > RockpiX/install/Ubuntu | Install Ubuntu to ROCK Pi X (..."