RockpiS/network-management - Revision history

Sawyer at 09:21, 8 September 2021

2021-09-08T09:21:52Z

Stephen at 06:30, 12 August 2020

2020-08-12T06:30:45Z

Stephen: /* Part 1: Set Ethernet static IP Address */

2020-08-12T06:27:38Z

‎Part 1: Set Ethernet static IP Address

Stephen: /* Part 1: Set Ethernet static IP Address */

2020-08-12T06:27:06Z

‎Part 1: Set Ethernet static IP Address

Stephen at 03:25, 8 May 2020

2020-05-08T03:25:10Z

Stephen at 11:58, 7 May 2020

2020-05-07T11:58:06Z

Zzl: /* Introduction */

2020-05-07T07:54:24Z

‎Introduction

Zzl at 07:53, 7 May 2020

2020-05-07T07:53:48Z

Stephen: Created page with "{{rockpiS_header}} {{Languages|rockpiS/dev/usbnet}} ROCK Pi S > ROCK Pi S Network Management This guide describes how to..."

2020-05-07T06:39:36Z

Created page with "{{rockpiS_header}} {{Languages|rockpiS/dev/usbnet}} ROCK Pi S > ROCK Pi S Network Management This guide describes how to..."

New page

{{rockpiS_header}}

{{Languages|rockpiS/dev/usbnet}}

[[rockpiS | ROCK Pi S]] > [[RockpiS/network-management | ROCK Pi S Network Management]]

This guide describes how to manage the network on ROCK Pi S.

=== Introduction ===

=== Troubleshooting ===

* Refer [[RockpiS/getting_started/troubleshooting | Troubleshooting page]]
* Post your issue on the forum: https://forum.radxa.com/c/rockpiS

@@ Line 11: / Line 11: @@
 Install some dependency packages
-  root@rockpis:~# apt-get install netplan.io
+  root@rockpis:~# apt-get install -y netplan.io
 Create file, /etc/netplan/01-ethernet.yaml. If there is no /etc/netplan folder, create it.

@@ Line 52: / Line 52: @@
         valid_lft forever preferred_lft forever
      inet6 fe80::c068:e0ff:fe7c:9b09/64 scope link
         valid_lft forever preferred_lft forever
 </pre>

@@ Line 17: / Line 17: @@
   root@rockpis:~# touch /etc/netplan/01-ethernet.yaml
-Add the following contents to the file, /etc/netplan/01-netcfg.yaml and save it.
+Add the following contents to the file, /etc/netplan/01-ethernet.yaml and save it.
 <pre>

@@ Line 13: / Line 13: @@
   root@rockpis:~# apt-get install netplan.io
-Create file, /etc/netplan/01-netcfg.yaml. If there is no /etc/netplan folder, create it.
+Create file, /etc/netplan/01-ethernet.yaml. If there is no /etc/netplan folder, create it.
-  root@rockpis:~# touch /etc/netplan/01-netcfg.yaml
+  root@rockpis:~# touch /etc/netplan/01-ethernet.yaml
 Add the following contents to the file, /etc/netplan/01-netcfg.yaml and save it.
- root@rockpis:~# cat /etc/netplan/01-netcfg.yaml
+<pre>
- network:
+root@rockpis:~# cat /etc/netplan/01-ethernet.yaml
-   ethernets:
+network:
-     eth0:
+  version: 2
-       addresses:
+  renderer: networkd
-         - 192.168.1.135/24
+  ethernets:
-       gateway4: 192.168.1.1
+    eth0:
-       nameservers:
+      addresses:
-         addresses:
+        - 192.168.1.200/24
-           - "8.8.8.8"
+      gateway4: 192.168.1.1
-   renderer: networkd
+      nameservers:
-   version: 2
+        addresses:
 Run the commands below to apply your changes.
@@ Line 45: / Line 48: @@
 root@rockpis:~# ip addr show dev eth0
 : eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UNKNOWN group default qlen 1000
-     link/ether 9e:a0:07:50:41:83 brd ff:ff:ff:ff:ff:ff
+     link/ether c2:68:e0:7c:9b:09 brd ff:ff:ff:ff:ff:ff
-     inet 192.168.1.135/24 brd 192.168.1.255 scope global eth0
+     inet 192.168.1.200/24 brd 192.168.1.255 scope global eth0
         valid_lft forever preferred_lft forever
-     inet6 fe80::9ca0:7ff:fe50:4183/64 scope link
+     inet6 fe80::c068:e0ff:fe7c:9b09/64 scope link
         valid_lft forever preferred_lft forever
 </pre>

@@ Line 5: / Line 5: @@
      [[rockpiS | ROCK Pi S]] > [[RockpiS/network-management | Network Management]]
-This guide describes how to manage the network on ROCK Pi S.
+This guide describes how to manage the network on ROCK Pi S running Ubuntu system.
-=== Introduction ===
+=== Part 1: Set Ethernet static IP Address ===
-Rockpis static address settings.First, install some dependency packages
-    sudo apt-get install netplan.io
-Create the '''01-netcfg.yaml'''  file in the folder /etc/netplan. If there is no netplan folder, you need to create.
-    sudo mkdir /etc/netplan
-    sudo touch /etc/netplan/01-netcfg.yaml
-Add the following to the file '''01-netcfg.yaml'''
-   rock@rockpis:/etc/netplan$ cat 01-netcfg.yaml
-    network:
-  version: 2
-  renderer: networkd
-  ethernets:
-    eth0:
-      addresses:
-        - 192.168.2.135/24
-      gateway4: 192.168.2.1
-      nameservers:
-          search: [mydomain, otherdomain]
-          addresses: [192.168.2.1, 255.255.255.0]
-Execute the following command for the configuration to take effect
+Install some dependency packages
-    sudo netplan apply
-then reboot,IP address is what you set.
+ root@rockpis:~# apt-get install netplan.io
 === Troubleshooting ===

@@ Line 3: / Line 3: @@
 {{Languages|rockpiS/dev/usbnet}}
-     [[rockpiS | ROCK Pi S]] > [[RockpiS/network-management | ROCK Pi S Network Management]]
+     [[rockpiS | ROCK Pi S]] > [[RockpiS/network-management | Network Management]]
 This guide describes how to manage the network on ROCK Pi S.

← Older revision		Revision as of 07:53, 7 May 2020
Line 8:		Line 8:

	=== Introduction ===		=== Introduction ===
		+	Rockpis static address settings.First, install some dependency packages
		+	sudo apt-get install netplan.io
		+	Create the'''01-netcfg.yaml''' file in the folder /etc/netplan.If there is no netplan folder, you need to create.
		+	sudo mkdir /etc/netplan
		+	sudo touch /etc/netplan/01-netcfg.yaml
		+	Add the following to the file '''01-netcfg.yaml'''
		+	rock@rockpis:/etc/netplan$ cat 01-netcfg.yaml
		+	network:
		+	version: 2
		+	renderer: networkd
		+	ethernets:
		+	eth0:
		+	addresses:
		+	- 192.168.2.135/24
		+	gateway4: 192.168.2.1
		+	nameservers:
		+	search: [mydomain, otherdomain]
		+	addresses: [192.168.2.1, 255.255.255.0]

		+	Execute the following command for the configuration to take effect
		+	sudo netplan apply
		+	then reboot,IP address is what you set.